The Sony LinkBuds S can get dirty easily, especially if you use it often. To see how you can properly clean these wireless headphones, as well as the included charging case, you can take a look at this guide from Seeking Tech.
What cleaning solution should you use for the Sony LinkBuds S?
When it comes to the type of cleaning solution you should use with the Sony LinkBuds S, we recommend getting a high-concentration isopropyl alcohol mixture as it will also act as a disinfectant. Furthermore, this mixture will also evaporate a lot quicker when compared to plain water, making it a lot less likely to cause any water damage.
If you are searching for a specific product, then we recommend picking up the MG Chemicals 99.9% Isopropyl Alcohol Electronics Cleaner Liquid Bottle, which you can find on Amazon with this link. (#CommissionsEarned).
What other cleaning tools do you need for Sony LinkBuds S?
Since the ear buds and charging case of the LinkBuds S are small, then we recommend that you use Q-tip cotton swabs as you will be able to get into the smaller nooks and crannies.
How to clean the Sony LinkBuds S
In order to clean the Sony LinkBuds S, we recommend that you take the following steps:
1. If you are currently using the Sony LinkBuds S, then make sure that you take if off of your ears.
2. You should then disconnect the wireless ear buds from the connected device.
3. Afterwards, make sure that you turn off the Sony LinkBuds S.
If you don’t know how to shut down the wireless earphones, then you can take a look at this tutorial.
4. If the charging case is connected to a power source, then you need to disconnect it from the USB power cable.
5. You should remove the ear buds from the charging case if you have them inside.
6. Once you are ready, gently twist off the ear bud tips from the left and right ear buds.
7. You should then apply the isopropyl alcohol to a Q-tip cotton swab.
Do not pour the solution directly on the ear buds or charging case as you could end up causing liquid damage.
We also recommend using multiple Q-tip cotton swabs, especially if your device is very dirty. Once a Q-tip starts to look dirty, then you can replace it with a new one.
8. Use the cotton swab to wipe off any ear wax, dirt and other types of residues on the ear buds and ear bud tips.
Pay special attention to the charging ports on the ear buds. If these are dirty, then you won’t be able to recharge your wireless ear buds.
9. Once you are done cleaning the ear buds and ear bud tips, gently twist the ear bud tips back into the ear buds.
10. Afterwards, you should place the ear buds with the IR sensors facing sideways or upwards. Otherwise, the sensors may accidentally detect that the buds are being worn and then turn them on.
11. Next, you can move on to cleaning the charging case.
Once again, make sure you pay special attention to the charging ports of the case. This is because that, if these are dirty, then you may not be able to recharge your wireless ear buds.
12. Once you are done cleaning the charging case, leave the lid open so that any excess solution will evaporate more easily.
13. Wait for the charging case and ear buds to fully dry out at room temperature.
14. Once the charging case and ear buds have dried, you can start using the ear buds normally again. You can also put the ear buds back to the charging case and recharge the charging case without any problems.