The WH-1000XM5 will get dirty over time. To see how you can properly clean the wireless headphones, you can take a look at this tutorial at Seeking Tech.
What cleaning cloth can use you use for WH-1000XM5?
When it comes to cleaning the WH-1000XM5, Sony recommends that you use a soft cloth. A more abrasive cleaning tool could end up scratching the exterior of the product.
If you are looking for a specific recommendation, the we suggest picking up the MagicFiber Microfiber Cleaning Cloth, which you can find on Amazon with this link. (#CommissionsEarned).
To clean smaller nooks and crannies of the headset, you can use cotton swabs.
What cleaning solution can you use for WH-1000XM5?
Since the WH-1000XM5 doesn’t offer any water resistance, you should ideally avoid using any liquid when cleaning the headphones.
If the product is so dirty that a dry cloth won’t be able to properly clean it, however, then you can use either plain water or a solution that contain a high concentration of isopropyl alcohol.
Out of these two options, we recommend picking up isopropyl alcohol as it will not only dry out a lot faster than plain water, but it will also disinfect the WH-1000XM5.
If you are looking for a specific recommendation for the headphones, then we suggest getting the MG Chemicals 99.9% Isopropyl Alcohol Electronics Cleaner, which you can purchase from Amazon with this link. (#CommissionsEarned).
Benzene, thinner, as well as other types of alcohol or solvents could end up damaging the headset. Therefore, you should stick with either plain water or isopropyl alcohol.
How to clean the WH-1000XM5
In order to properly clean the Sony WH-1000XM5, we recommend that you take the following steps:
1. To begin, make sure that the headset is completely turned off.
2. Furthermore, you should also disconnect the USB cable and headphone cable if you have those attached.
3. You should remove any other accessories you have connected as well.
4. Apply plain water or isopropyl alcohol to the cleaning cloth or cotton swab.
Make sure that it doesn’t get too damp to the point where it is dripping liquid. If it does, then you need to squeeze out the excess solution.
Do not apply the plain water or isopropyl alcohol directly onto the WH-1000XM5. As we stated previously, the headphones offer no water resistance. Therefore, the solution can easily get inside and cause liquid damage.
5. Next, you can wipe clean your headset. When wiping, use the circular motion to efficiently remove dirt and grimes.
6. After cleaning, you need to wait until the WH-1000XM5 air dries.
You can speed the drying process by putting the headphones near a fan, which will provide increase air circulation.
What you need to avoid doing is using heat source, such as a hair blow dryer, to dry the headset. Otherwise, you could end up damaging your WH-1000XM5.
7. Once you are sure that the product has fully dried, you should be able to use it normally again.